Best Garage for Worx Landroid: Match Your Model First
8 min read · by Jordan Ellis · Updated
The best garage for Worx Landroid is the one listed for your exact model code, with room around the charging station and a roof that does not trap heat. Worx sells different garages for different Landroid models, so the code printed on your mower decides the fit before size or style. Then check the roof, airflow, anchoring and drainage.
The short answer
- Model first: Worx’s WA0810 garage is listed for wired models WR139E, WR140E, WR149E and WR150E, and the page says it is not suitable for Vision models WR206E and WR213E.
- Size: the WA0810 measures about 71 cm high, 55 cm wide and 40 cm deep, according to Worx Australia.
- Roof: a shaded, ventilated roof is better than a sealed dark box, because heat traps are not shade.
- Anchor: the WA0194 garage can sit above the charging station or screw into the ground, with 14 screws and 14 pegs in the box.
- Winter: a garage does not replace indoor storage when temperatures fall below zero.
Why the best garage for Worx Landroid starts with the model code
Worx does not sell one universal garage for every Landroid, and if you are not sure you need one at all, start with whether a robot mower needs a garage. Its Australian product page for the WA0810 Robot Lawn Mower Garage with Flip up Cover lists it for wired models WR139E, WR140E, WR149E and WR150E, and says it is not suitable for Landroid Vision models WR206E and WR213E. The page describes the garage as fitting all Worx Landroid wired models, which is a narrower claim than fitting every Landroid.
The European product page for the WA0194 garage uses a different list of compatible codes, including WR168E, WR141E and WR155E. So the same garage name can cover different model families in different regions. Our reading is that the best garage for Worx Landroid is the one that matches the code on your mower and on the garage listing, not the marketing name or a photo.
Heads up
We could not open a Worx page with verified dimensions for the Vision garages. Treat any Vision size you see in a listing as unconfirmed until you check it against the manual or the official Worx page for your exact model.
Measure the charging station and the space around it
Measure the mower, the charging station and the space beside them before you compare any garage, because the station footprint sets the inside width and depth you need. Mammotion’s garage guide gives a general rule of the mower width plus at least 4 to 6 inches of clearance on each side. That rule is a starting point for the best garage for Worx Landroid, not a substitute for your model’s numbers, since garages are sized to specific mowers and stations. Our robot mower garage size guide explains how to measure.

| Check | What to look for | Why it matters |
|---|---|---|
| Model code | Garage listed for your exact Landroid code | Compatible lists differ between regions and garages |
| Footprint | Room for the station plus the clearance rule above | A tight fit makes entry and exit harder |
| Height | Room above the mower and the station | Avoids a cramped top and a blocked lid |
| Approach | A clear, straight path into the front opening | The mower needs a clean run into the dock |
| Roof material | Non-metal roof over the station | Mammotion advises against metal roofs where RTK positioning is used |
| Anchoring | Pegs, screws or a fixing system in the box | Wind and mower movement can shift a loose shelter |
Roof, shade and airflow
A roof should block rain and sun without holding heat in. The WA0810 has a hinged roof that Worx says protects against wind, leaves, rain and direct sunlight, and the page says the materials are water-resistant and protect against UV. The control panel stays reachable under the roof, which matters for daily use.
Water resistance is not the same as shelter, and that holds for any roof you pick for the best garage for Worx Landroid. Eufy says its IPX6 rating is for rain and splashes, not constant direct exposure, so a rating on the spec sheet does not replace a roof in a wet or exposed yard. Mammotion makes a related point: heat traps are not shade, because enclosed, dark designs with little airflow can run hotter than the open air, and constant sunlight can fade plastics. Eufy also says most robotic mower systems operate best between 0 and 45 degrees Celsius, so a sealed box in a hot yard is a poor choice.

Anchoring and drainage
A garage that moves in wind or sits in water is a problem. The WA0194 garage can be mounted above the charging station or screwed directly into the ground for stability, and its box includes 14 screws and 14 pegs. Robomow says manufacturer garages usually fit snugly on two or three sides and are attached to the ground with pegs, so check that the pegs and fixings suit your lawn surface. A robot mower charging station base plate is one way to give the dock a firm, level footing.
Drainage matters for the charging contacts. Mammotion suggests raising the base slightly, setting it on gravel or pavers, and avoiding low spots where water collects. Our reading is that the best garage for Worx Landroid will not keep the station dry if it sits over a puddle, even with a good roof.
Winter, snow and frost
A garage helps with rain, sun and snow load, but it is not a frost-proof store. Worx says the WA0194 safeguards the Landroid from rain, snow and excessive sun. Robomow, by contrast, says garages do not provide adequate frost protection and advises storing the mower indoors when temperatures drop below zero.
Treat any garage, including the best garage for Worx Landroid, as shelter from weather rather than winter storage. Check the storage temperature in your Landroid manual before the first hard frost, because the rules for one brand do not always carry over to another model. Our robot mower winter storage guide covers the indoor routine.
Choosing the best garage for Worx Landroid in five steps
Five checks cover most decisions. Work through them in order, because the first one, model fit, rules out the others.
- Confirm the model code. Read the code on the mower and match it to the garage’s compatible list, not just the Worx name.
- Measure the station and space. Add clearance beyond the mower width on each side and check the height above the station.
- Check the roof and airflow. Pick a shaded, ventilated, non-metal roof over a sealed dark box. If no Worx garage fits, see our guide to the best universal robot mower garage.
- Plan anchoring and drainage. Use the pegs or screws in the box, raise the base slightly and keep water away from the contacts.
- Plan the cold months. Confirm the storage temperature in your manual and move the mower indoors before hard frost.
Our reading is that a garage pays off most in exposed yards, where sun, rain and temperature swings are harder on the mower. In a sheltered yard, a roofed dock with good drainage may do much of the same work. Either way, for the best garage for Worx Landroid, the model code decides the size.

Frequently asked questions
Is there one best garage for every Worx Landroid?
No. Worx lists different garages for different Landroid codes, and the lists differ by region. The WA0810, for example, is listed for wired models and states it is not suitable for Vision models WR206E and WR213E. Check your code before you compare designs, because the best garage for Worx Landroid depends on it.
How big is the WA0810 garage?
Worx Australia lists the WA0810 at about 71 cm high, 55 cm wide and 40 cm deep. Compare those figures with your station footprint and the clearance rule, because a station with extra cables or a wider base may need more room.
Can I use a metal roof over a Worx Landroid garage?
Mammotion advises against metal roofs where RTK positioning is used, because metal can interfere with satellite reception. Check whether your model relies on RTK before you choose a metal roof, and prefer a non-metal roof if you are unsure.
Does a garage protect a Landroid from freezing weather?
Not fully. Robomow says garages do not provide adequate frost protection and advises storing the mower indoors when temperatures drop below zero. Worx markets its garage as protection from snow, but the storage temperature in your manual is the number to follow.
Sources
- Worx Australia: WORX LANDROID Robot Lawn Mower Garage with Flip up Cover, WA0810 (manufacturer): dimensions, compatible wired codes, Vision exclusion, hinged roof and UV protection.
- Worx Europe: Landroid garage WA0194 (manufacturer): compatible codes, mounting above the station or into the ground, box contents, protection from rain, snow and sun.
- Mammotion: Robot lawn mower garage guide (vendor guide): clearance rule, metal roofs and RTK, drainage, heat and sun.
- Eufy: Do you need a robotic lawn mower garage? (vendor guide): IPX6 limits and the 0 to 45 C operating range.
- Robomow: Which robotic lawnmower garage is the right one (vendor guide): fit on sides, ground pegs, frost limit.
01Up next8 min readGearWorx Landroid Spare Parts: What Exists and How to Match ItUpdated Nov 19, 2026
028 min readGearUniversal Boundary Wire for Worx Landroid: What to MatchUpdated Nov 11, 2026
039 min readGearWorx Landroid Replacement Battery: Fit, Swap and 1-Year WarrantyUpdated Nov 19, 2026
048 min readGearWorx Landroid Accessories Worth Buying: 4 Essential PicksUpdated Nov 20, 2026
057 min readGearWorx Landroid Replacement Blades: Pack, Timing, and FitUpdated Nov 20, 2026
067 min readGearWorx Landroid Charging Station: Placement, Limits, and FixesUpdated Nov 13, 2026