How long does the Ecovacs GOAT O1000 battery last?
7 min read · by Rachel Whitman · Updated
How long does the Ecovacs GOAT O1000 battery last? Ecovacs’ own spec pages list about 65 to 90 minutes of mowing on one charge, depending on which O1000 variant you read, and a full recharge of roughly 70 to 120 minutes. Battery life across years is not stated on either page, so the figures below are the starting point for checking your own unit.
The short answer
- Per charge: the O1000 RTK page lists about 65 minutes of continuous mowing, while the O1000 LiDAR PRO page lists 90 minutes.
- Recharge: the pages give about 100 and 70 minutes, and Ecovacs’ help center gives about 120 minutes for a 0 to 100 percent charge.
- Cold weather: at 8 °C (14 °F) or below, the station charges slowly, and a full charge can take 3 to 5 hours.
- Years of use: neither spec page states a cycle life or battery warranty length, so check the warranty terms for your exact model.
What the battery spec says
The question “how long does the Ecovacs GOAT O1000 battery last” starts with the spec pages, but the two US product pages do not match. The RTK version lists a 4,000 mAh pack, and the LiDAR PRO version lists 5,200 mAh. Both list 18 V and a lithium-ion chemistry. The difference matters because, in our reading, a larger pack should support a longer mowing run, though lawn conditions also set how long the run lasts.

| Spec | O1000 RTK page | O1000 LiDAR PRO page |
|---|---|---|
| Voltage | 18 V (listed as Energy Platform) | 18 (listed as Energy Platform) |
| Battery capacity | 4,000 mAh | 5,200 mAh |
| Battery type | Lithium-ion | Lithium-ion |
| Mowing time per charge | About 65 minutes (continuous) | 90 minutes |
| Charging time | About 100 minutes | 70 minutes |
| Cycle life or battery warranty | Not stated | Not stated |
Our reading: a 4,000 mAh pack and a 5,200 mAh pack should not be expected to give the same runtime, so the page you use for comparison must match your exact model. Ecovacs’ spec tables are the most direct source, and the model name on your mower’s label is the way to match it. Check the O1000 manual and the mower’s app for the figure that applies to your unit.
How long does the Ecovacs GOAT O1000 battery last on one charge?
A single mowing run ends when the battery is low, not when the lawn is finished. Ecovacs’ help-center FAQ on working time says the mower returns to its station when the battery drops below 15 percent, then recharges to 80 percent before it resumes from where it stopped. The same FAQ says the GOAT software has no fixed working-time limit, so the mower can in theory keep cutting until the battery is depleted, though the station cycle changes how that works in practice.
This matters for how you read a runtime figure. A 90-minute rating does not mean 90 minutes of cutting in every session. In a normal cycle the mower works from 80 percent down to 15 percent, then charges back up. Our guide on how often a robot mower needs to charge covers the wider picture. Our reading is that most of the stated runtime is used per trip, and the lawn size sets how many trips it needs. So a lawn that needs more than one charge’s worth of mowing will be cut over several cycles, not one long continuous run.
Ecovacs’ FAQ also advises against mowing in rain and after dark, which can limit when the mower runs even if the battery is good. That advice affects the total weekly mowing time more than the per-charge figure does.
How long a full charge takes
Ecovacs gives charge times in more than one place, and the numbers do not fully agree. The O1000 RTK page lists about 100 minutes, the LiDAR PRO page lists 70 minutes, and the charging FAQ lists about 120 minutes from 0 to 100 percent, with about 70 minutes from 20 to 80 percent. The FAQ names the model as the O1200 with the O1000 in brackets, which suggests the label varies across Ecovacs material.

Heads up
The charging figures depend on which Ecovacs page or FAQ you read, and on which model label appears. Treat 70 to 120 minutes as the range for a full charge, and confirm the number in the manual that came with your mower.
Cold weather adds time. Ecovacs’ FAQ says that when the battery temperature is 8 °C (14 °F) or below, the station switches to a low-current mode to protect the cells. A full charge can then take 3 to 5 hours. This is the same mower, so a cold morning can delay the next cutting run even though the battery has not changed. For general working limits, see what temperature a robot mower can work in.
What shortens working time
Several things change how long the Ecovacs GOAT O1000 battery lasts in a session. Ecovacs’ help center lists three reasons a GOAT may run for less time than expected after a full charge: dense grass and complex terrain, high-efficiency mode, and battery degradation. The FAQ does not give figures for any of them, so the effect of each one on your lawn has to be judged from your own observations. If runs keep getting shorter, see robot mower battery draining fast.
High-efficiency mode is the easiest to change. Ecovacs says it cuts faster, and our reading is that faster cutting uses the battery sooner. Dense or uneven grass likely asks more of the mower for the same area, though the FAQ does not quantify this. Battery degradation is the slow one: the FAQ says long-term use can wear the battery and lengthen charging times, which means the runtime you see when the mower is new may not match the runtime in later years. Replacement options are covered in the Ecovacs GOAT replacement battery guide.
What to check before you rely on the runtime
A few checks make the spec figures useful when you ask how long does the Ecovacs GOAT O1000 battery last in your own yard. We recommend these steps, based on the Ecovacs sources above rather than on any test of the mower.
- Match the model. Confirm whether your mower is the RTK or the LiDAR PRO version, since the battery figures differ.
- Measure your lawn. Estimate the area and compare it with the mower’s rated coverage, because runtime needed rises with area.
- Read the manual. Find the working-time and charging sections for your exact model, not the marketing page. Our how to set up the Ecovacs GOAT O1000 guide covers the app side.
- Track one week. Note how many cycles the mower takes to finish, and whether it returns to the station before the job is done.
- Check the warranty. Ecovacs has a Returns & Warranties page, but neither spec page gives a battery-specific figure, so read the battery terms there before buying.
Frequently asked questions
How many minutes does the O1000 run on a single charge?
Ecovacs’ spec pages give about 65 minutes of continuous mowing for the O1000 RTK and 90 minutes for the O1000 LiDAR PRO. The figure depends on the variant and on lawn conditions, so check the manual for your exact model.
How long does it take to fully charge the GOAT O1000?
The pages list about 100 minutes for the RTK version and 70 minutes for the LiDAR PRO version. Ecovacs’ charging FAQ gives about 120 minutes from 0 to 100 percent, and about 70 minutes from 20 to 80 percent.
Does the mower stop mowing when the battery is low?
Yes. According to Ecovacs’ help-center FAQ, the mower returns to its station below 15 percent battery and resumes after charging to 80 percent, picking up from where it stopped.
How long does the Ecovacs GOAT O1000 battery last over several years?
Neither spec page gives a cycle life or a battery warranty length. Ecovacs’ FAQ says long-term use can wear the battery and lengthen charging times, so the runtime is likely to drop over time. Check the warranty terms for your exact model before you buy.
Sources
- ECOVACS GOAT O1000 RTK product page (Ecovacs): battery capacity 4,000 mAh, about 65 minutes continuous mowing, about 100 minutes charging.
- ECOVACS GOAT O1000 LiDAR PRO product page (Ecovacs): battery capacity 5,200 mAh, 90 minutes mowing per charge, 70 minutes charging.
- Why does GOAT charge slowly? (Ecovacs help center): charge times for 0 to 100 and 20 to 80 percent, and the cold-temperature charging behavior.
- Does GOAT have a working time limit? (Ecovacs help center, Polish-language page): the 15 percent return threshold and the 80 percent resume point.
- Why does the working time of GOAT shorten after being fully charged? (Ecovacs help center): dense grass, high-efficiency mode and battery degradation.
01Up next6 min readLearnHow to Update Ecovacs GOAT O1000 FirmwareUpdated Nov 12, 2026
029 min readLearnHow to Set Up Ecovacs GOAT O1000: Step-by-Step GuideUpdated Nov 10, 2026
039 min readLearnHow Long Does the Anthbot M5 Battery Last?Updated Nov 11, 2026
047 min readLearnHow Long Does the Dreame A1 Pro Battery Last?Updated Nov 12, 2026
057 min readLearnHow Long Does the eufy E15 Battery Last?Updated Nov 12, 2026