How to Store a Robot Lawn Mower in Winter
7 min read · by Rachel Whitman · Updated
How to store a robot lawn mower in winter: clean it, set the battery to a safe charge level, switch it off, and keep it indoors in a dry place above freezing. Husqvarna’s winter storage guide and Anker’s winter article agree on these core steps, but they give different battery levels, so the mower’s own manual should have the final word. This guide covers each step and how to handle the charging station and boundary wire.
The short answer
- Clean first: remove dried grass and dirt from the deck, wheels, sensors, and charging contacts.
- Set the battery: Husqvarna says to charge fully before storage; Anker says to leave about 50 to 80 percent.
- Store indoors: a garage, shed, utility room, or basement where temperatures stay above freezing.
- Charging station: bring it in if you can. If it must stay outside, keep it powered and covered.
- Boundary wire: it can stay in the ground, but only if the charging station stays connected.
When to start winter storage
Start storage when nights regularly drop toward freezing, not on the first chilly morning. Anker suggests starting once nights regularly fall below around 5°C (41°F). Husqvarna’s guide sets the indoor requirement instead: keep the mower where temperatures stay above freezing, which it gives as above 0°C (32°F). Our reading is that a mower left out through a frost is at risk, so bring it in before the first hard frost in your area. Storage begins when growth stops, and stopping the mower in fall describes how to judge that moment.
Clean the mower before putting it away
Clean the mower before storage so dried grass and grit do not sit on the cutting deck and corrode over the winter. A clean mower is the first part of knowing how to store a robot lawn mower in winter without damage. Anker recommends turning the mower fully off, brushing away dried grass and dirt, and wiping the outer casing with a damp cloth. Clean around the wheels and the cutting deck, then gently wipe the sensors and the charging contacts. Anker advises against a pressure washer unless the manual says it is safe for your model.
Husqvarna adds a few checks while the mower is clean. Inspect the body and blade disc for damage and wear, look for corrosion on the charging contacts, and fit new blades and screws if the old ones are worn. Sharp, rust-free blades are easier to deal with in spring than blades that have been left to corrode.

Set the battery charge before storage
This is where the two sources differ most, and the difference matters. Husqvarna’s guide says to fully charge the mower and switch it off before storage. It also notes that most models need no charging during storage, but some older models need a top-up about every three months. Anker says to store the mower with somewhere between 50 and 80 percent charge left, and to avoid leaving the battery fully drained. A weak pack deserves attention before it sits for months, so battery health checks before storage can save a spring surprise.
| Source | Battery advice before storage | What it means for you |
|---|---|---|
| Husqvarna winter guide | Fully charge, then switch off | Check whether your model needs a top-up every few months |
| Anker winter article | Between 50% and 80% charge | Avoid a flat battery over winter |
Our reading is simple: if your manual gives a number, use that number. If it does not, a mid-range charge avoids a flat battery and avoids leaving a full battery sitting for months. Either way, set a reminder to check the battery partway through winter, especially if the mower is an older model.
Heads up
Removable batteries follow the same logic, but they should be stored indoors even if the mower itself is kept elsewhere. A battery left in a cold shed can lose capacity faster than one kept in a warm room.
How to store a robot lawn mower in winter indoors
Store the mower in a dry, frost-free place such as a garage, an insulated shed, a utility room, or a basement. Anker’s guide says leaving a robot mower outside through winter is not recommended, and Husqvarna lists indoor storage with the mower, charging station, and power supply as the default. Keep the mower off bare concrete if that area gets damp, and do not stack heavy items on top of it. A garage or shed is the usual choice, and unheated shed storage covers the temperature rules to check.

Handle the charging station and boundary wire
The charging station is the part most people leave outside by mistake. Husqvarna’s guide says the charging station can stay outdoors only if it stays connected to mains power, and that the boundary and guide wires must stay connected to it. Its NERA baseplate can stay outside, and its EPOS reference station is weatherproof and can stay outside year-round as long as the power supply stays connected. Anker says many manufacturers recommend bringing the charging station inside during winter, especially in colder or wetter areas. The base may stay in the yard, and charging station care for the Landroid shows how one brand handles power and mounting. Disconnecting power also protects against surges, and unplugging before storms and storage describes the correct order for reconnecting.
The boundary wire can stay in the ground over winter. Husqvarna notes that boundary and guide wires stay in place, and they only need to stay connected if the charging station is outdoors. If you bring the station in, disconnect the wire at the station and leave the rest of the loop buried.
Check the mower before spring
Before the first mow of the season, check the charging contacts for corrosion, look over the blades, and make sure the charging station is clean and connected. Install any firmware updates in the manufacturer’s app before you start the mower again. Our suggestion, not a manufacturer rule, is to run a short test with the mower on a small patch of lawn before you let it run its full schedule. After storage, restart timing matters, and when to start mowing again in spring covers the first weeks.
Frequently asked questions
Can a robot lawn mower stay outside in winter?
Neither source recommends it. Anker says it is not recommended to leave a robot mower outside during winter, and Husqvarna’s default is indoor storage above freezing. If you have no choice, use a protective cover and keep it as dry as possible.
Should I fully charge my robot mower before winter storage?
Husqvarna says to fully charge and switch it off, while Anker says to leave about 50 to 80 percent. Check the manual for your model first. If the manual is silent, a mid-range charge is a sensible middle ground.
Do I need to keep the charging station connected in winter?
Only if it stays outdoors. Husqvarna says an outdoor charging station should stay connected to mains power, and the boundary and guide wires should stay connected too. If you bring the station indoors, you do not need to keep it powered.
What should I check before using the mower again in spring?
Check the charging contacts for corrosion, inspect the blades, clean the sensors, and make sure the charging station and boundary wire are connected. Update the firmware through the app before the first mow.
Sources
- Husqvarna Automower winter storage guide (manufacturer): battery charge before storage, cleaning, indoor storage, charging station and boundary wire outdoors, and temperature limits.
- Anker robot lawn mower winter storage article (manufacturer): the 50 to 80 percent battery range, the around 5°C start point, the cleaning steps, and the advice to keep the mower indoors.
01Up next6 min readLearnIs It OK to Store a Robot Mower in an Unheated Shed?Updated Nov 14, 2026
028 min readLearnCan a Robot Mower Stay Outside in Winter?Updated Nov 11, 2026
039 min readLearnHow to Make a Robot Mower Last Longer: Battery, Blade, and Winter CareUpdated Nov 11, 2026
046 min readLearnMammotion App Not Connecting: Luba Fixes That WorkUpdated Nov 13, 2026
056 min readLearnEcovacs GOAT Factory Reset: Step-by-Step GuideUpdated Nov 13, 2026
067 min readLearnAre Robot Lawn Mowers Worth It in 2026? Cost, Time and PaybackUpdated Nov 13, 2026