Robot Mower for a Lawn with a Putting Green: Fence It Off
6 min read · by Laura Kessler · Updated
A robot mower for a lawn with a putting green is usually a poor match for the green itself. Most residential robot mowers cut between about 20 and 60 mm, and Robomow notes that no robot on the market mows a lawn shorter than 15 mm. A putting green is cut far lower than that and is much more delicate than a home lawn. The practical answer is to fence the green off from the mower and let the robot handle the rest of the yard.
The short answer
- Check the lowest cutting height before you think about the green. A mower that cannot cut low enough will leave the green too long.
- Keep the green fenced off with boundary wire or a stay-out zone, so the mower does not drive over it.
- Use the one-third rule on the rest of the lawn: never remove more than one-third of the blade length in a single mowing.
- Cut the green separately with a tool built for it, rather than expecting the robot to do the job.
Why a putting green is a different job
A putting green is a dense, fine-bladed surface that is kept very short and rolled smooth. Robomow describes ornamental lawns as dense with fine blades that handle wear poorly, and says a lush ornamental green is much more sensitive than a commercial lawn. Robomow also notes that such turf can be cut as low as 2 cm (20 mm), which is still higher than most putting greens are kept. A putting green is one of several lawn games, and toys and games on a robot-mowed lawn covers the others. Another precision lawn game has its own rules, as croquet court lawn setup describes.
A residential robot mower is built for a general lawn. Its blades and deck are set up for a height range of roughly 20 to 60 mm on many models, so it is not designed to hold a green at putting height. Our reading is that asking a robot to cut a putting green is asking it to work outside its normal range.
Check the lowest height before anything else
The lowest setting on a robot mower is the first thing to check. Robomow’s guidance is that no robot on the market mows a lawn shorter than 15 mm, and that many models cut only between 20 and 60 mm. If the lowest setting is above the height your green needs, the mower cannot match the green, and the green will look ragged after a few runs. Lowest settings are limited by the mower, as Kentucky bluegrass cutting height for robots shows for turf species.
Compare the spec sheet with the height your green is kept at. If the rest of your lawn is cut at a normal height and the green sits far below it, the two surfaces need different equipment.

Keep the robot off the green
Whatever the mower’s height range, the green is the wrong place for it to drive. Mower wheels leave tracks and turn marks, and the blade’s cut can be uneven on a surface that short. Fence the green with boundary wire so the mower follows a loop around it, or use a stay-out zone on a wire-based model. Games that leave goals or hoops on the grass share the same boundary issues, as soccer goal lawn setup explains.
Robomow’s guidance on sensitive turf is that ornamental lawns are only suitable for limited loading, so keep wheel traffic off the green and let the mower work around it. A physical border around the green also keeps the mower from edging up to the green’s edge during turns.
Mow the rest of the lawn on a schedule
The robot does its best work on the main lawn, where a general cutting height is what you want. Robomow recommends a cutting length of 30 to 40 mm for general practice, since frequent mowing can slightly weaken a lawn. Its one-third rule is the same here: remove no more than one-third of the blade length per mowing, which is easiest to keep with frequent short runs. A scheduled run around fixed equipment is explained in basketball hoop lawn clearance.
Shade areas need a different approach. Robomow says shade lawns are best kept long, around 60 to 70 mm, so the blades can photosynthesize. If the robot cannot cut that high, keep the shaded section outside its zone and trim it by hand.

Cut the green with a tool made for it
A putting green needs the kind of cutting equipment built for close, fine turf. Our reading is that a hand-pushed or specialist greens mower is the right tool for the green, while the robot takes care of the surrounding lawn. Keep the two jobs apart: the green gets its own mowing routine, and the robot never enters that area.
If you want one machine to handle both, look for a model whose lowest setting reaches the height you need. Confirm that in the spec sheet, not in the marketing copy, because the lowest setting is what decides the result.
What to check before you buy
- Lowest cutting height: compare the minimum setting with the height your green and lawn need.
- Fencing support: confirm the model supports boundary wire or stay-out zones so the green can be kept off limits.
- Turf match: consider how the mower handles fine turf if the green and the lawn share a blade height range.
- Service access: check how easily the blades and deck can be reached for regular sharpening.
Related reads: Family lawns raise similar checks, which mower choice for family play lawns lists. Fine turf species suit certain mowers better, which ryegrass lawn mower recommendations covers.
Frequently asked questions
Can a robot mower cut a putting green?
Most residential robot mowers cannot cut a putting green at its usual height. Many cut only between about 20 and 60 mm. Check the lowest setting first, and keep the green fenced off.
What is the lowest height a robot mower can cut?
Robomow says no robot on the market mows a lawn shorter than 15 mm. Many residential models start at 20 mm, so the lowest setting varies by model.
How high should a robot mower cut a general lawn?
Robomow recommends 30 to 40 mm for general practice, and says commercial or play lawns can go to 35 to 55 mm. Keep to the one-third rule in every case.
Should I fence the green off from the robot?
Yes. Fence the green with boundary wire or a stay-out zone, so the mower does not drive over the fine turf. Our reading is that this is the simplest way to protect the green from tracks and turn marks.
Sources
- What is the ideal cutting height for a robotic lawnmower? (Robomow): recommended cutting lengths by lawn type, the 15 mm floor for robot mowers, the one-third rule, and the sensitivity of ornamental turf.
01Up next9 min readBy YardChoosing and Setting Up a Robot Mower for a Yard With a Split-Rail Wooden FenceUpdated Nov 19, 2026
027 min readBy YardRobot Mower for a Lawn With a Gravel Driveway: Keep It Off the DriveUpdated Nov 14, 2026
036 min readBy YardRobot Mower and Wood Chips Under a Swing Set: Keep It Off the ChipsUpdated Nov 14, 2026
046 min readBy YardRobot Mower for a Lawn With Utility BoxesUpdated Nov 13, 2026
056 min readBy YardRobot Mower for a Lawn with Voles: Signs, Limits, ControlUpdated Nov 13, 2026
066 min readBy YardRobot Mower for a Lawn With a Mailbox PostUpdated Nov 13, 2026